Starting the Engine, Controls and Gauges

Showing all 13 results

Active filters
Clear Filters
Other
ABS Light, – Turn the key partially on to calibrate, point out the ABS light came on Once it is done calibrating, point out the ABS light went out. Now you can start the engine.
Read more
Other
Hazard Lights (four-way Flashers), – Turn them on to show they work and turn back off.
Read more
Other
Headlights, – Show the high and low beams, and point this out in the cross-over mirrors.
Read more
Other
Heated Mirror, Rear Heater, and Defrost, – Turn these on and reach hand up by defrost and tell him they are all working
Read more
Other
Horn, – Honk the horn and say it is working.
Read more
Other
Parking Brake Test, – Make sure the parking brake is set, put your foot on the brake and put in drive, then rev the engine slightly and say the parking brake is working and holding good. Then shift in all gears to show and say the shifter is working.
Read more
Other
Speedometer and Service Brake Test, – Apply the brake, push the yellow knob in to release parking brake, drive about 5 mph and say that the speedometer is working , then firmly press the brake and say that the brakes are working
Read more
Other
Steering Wheel Controls, – Turn the Warning Lights on (Amber), then press open door and point pot the loading lights and stop arm is working properly. Then press “close door” and turn off warning (amber) lights.
Read more
Other
Steering Wheel, – Show that there is no more than 10% Play.
Read more
Other
Strobe Light and Dome lights, Turn on the rear, center, and driver dome lights and point that they are on and working. Also, turn on the strobe light.
Read more
Other
Turn Signals, – Turn the left and right signal on and point out that you see them working in the cross-over mirrors.
Read more
Other
Water Gauge, Oil Gauge, RPM Guage, and the Fuel Guage, – Are all working properly
Read more
Other
Windshield Fluid and Wipers, – Show they are working and also spray the windshield washer fluid to show it works.
Read more